Acura 3.5 RL Manual page 182

Cylinder Heads
Removal (cont'd)
18. Loosen the mounting bolt, lock bolt and adjusting
rod, then remove the alternator belt.
ADJUSTING
ROD
ALTERNATOR
BELT
19. Loosen the idler pulley center nut and adjusting bolt,
then remove the air conditioning (A/C) compressor
belt.
ADJUSTING
BOLT
A/C COMPRESSOR
BELT
LOCK BOLT
8 x 1.25 mm
22 N-m (2.2 kgf-m,
16 Ibf-ft)
MOUNTING BOLT
10 x 1.25 mm
44 N-m (4.5 kgf-m,
33 Ibf-ft)
IDLER PULLEY
CENTER NUT
10 x 1.25 mm
44 N-m (4.5 kgf-m,
33 Ibf-ft)
20. Loosen the adjusting bolt, locknut and mounting bolt,
then remove the power steering (P/S) pump belt (see
page 6-6).
21. Remove the vacuum hoses and breather hose.
VACUUM
HOSE
22. Remove the vacuum hoses, then remove the igni-
tion control module (ICM) bracket (see page 6-9).
23. Remove the engine wire harness connectors and
wire harness clamps from the cylinder heads and
intake manifold.
Six injector connectors
Six ignition coil connectors
Throttle position sensor connector
CKP/CYP sensor connector
Intake air temperature (IAT) sensor connector
Exhaust gas recirculation (EGR) valve connector
Idle air control (IAC) valve connector
Engine coolant temperature (ECT) sensor con-
nector
ECT gauge sending unit connector
Manifold absolute pressure (MAP) sensor con-
nector
Vehicle speed sensor (VSS) sub-connector
Left primary heated oxygen sensor (left primary
HO2S) connector
Right primary heated oxygen sensor (right pri-
mary H02S) connector
Ground cable (throttle body base)
BREATHER
HOSE