Bi: Motor Changeover Feedback Signal / Mot_Chng Fdbk Sig; Co/Bo: Motor Changeover Status Word / Mot_Chngov Zsw; Bi: Motor Changeover Contactor Feedback / Mot_Chg Cont Fdbk - Siemens SINAMICS G150 Manual

2 Parameters
2.2 List of parameters
Note: A motor is only changed over (a new motor selected) after the pulses have been suppressed.
When the motor data sets are changed over, the following applies:
Bit numbers that are not identical, signify that the motor must be changed over.
p0828[0...n]

BI: Motor changeover feedback signal / Mot_chng fdbk sig

VECTOR_G Can be changed: C2(3), T
Data type: Unsigned32 / Binary
P-Group: Motor
Not for motor type: -
Min
-
Description: Sets the signal source for the feedback signal when changing over the motor.
For p0833.0 = 1 the following applies:
This feedback signal (0/1 edge) is required after a motor changeover to enable the pulses.
Dependency: Refer to: p0833
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
r0830.0...15

CO/BO: Motor changeover status word / Mot_chngov ZSW

VECTOR_G Can be changed: -
Data type: Unsigned16
P-Group: Displays, signals
Not for motor type: -
Min
-
Description: Displays the status word of the motor changeover.
These signals can be connected to digital outputs to change over the motor.
Bit field: Bit
00
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
Dependency: Refer to: p0827
p0831[0...15]

BI: Motor changeover contactor feedback / Mot_chg cont fdbk

VECTOR_G Can be changed: U, T
Data type: Unsigned32 / Binary
P-Group: Motor
Not for motor type: -
Min
-
Description: Sets the signal source for the feedback signal of the contactors when changing over motors.
There is a fixed inter-relationship between energizing the contactor and the feedback signal.
252
Signal name
Motor selection bit 0
Motor selection bit 1
Motor selection bit 2
Motor selection bit 3
Motor selection bit 4
Motor selection bit 5
Motor selection bit 6
Motor selection bit 7
Motor selection bit 8
Motor selection bit 9
Motor selection bit 10
Motor selection bit 11
Motor selection bit 12
Motor selection bit 13
Motor selection bit 14
Motor selection bit 15
Calculated: -
Dyn. index: CDS, p0170
Units group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
1 signal
High
High
High
High
High
High
High
High
High
High
High
High
High
High
High
High
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
List Manual (LH2), 04/2014, A5E03263479A
Access level: 3
Func. diagram: 8575
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 2
Func. diagram: 8575
Unit selection: -
Expert list: 1
Factory setting
-
0 signal
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Low
Access level: 3
Func. diagram: 8575
Unit selection: -
Expert list: 1
Factory setting
0
SINAMICS G130/G150
FP
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-