Telegram Diagnostics Selection / Telegr Diag Sel; Telegram Diagnostics Signals / Telegr Diag Sig - Siemens SINAMICS G150 Manual

144: When checking the firmware that was downloaded (checksum), the component detected a fault. It is possible
that the file on the memory card/device memory is defective.
145: Checking the loaded firmware (checksum) was not completed by the component in the appropriate time.
156: Component with the specified component number is not available.
Additional values:
Only for internal Siemens troubleshooting.
Dependency: Refer to: p7828
Note: p7829 is automatically set to 0 after the firmware has been successfully downloaded.
The new firmware only becomes active at the next system run-up.
p7830

Telegram diagnostics selection / Telegr diag sel

ENC, VECTOR_G Can be changed: T
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description: Selects a telegram whose contents should be shown in r7831 ... r7836.
Value: 0:
1:
2:
3:
Dependency: Refer to: r7831, r7832, r7833, r7834, r7835, r7836
r7831[0...23]

Telegram diagnostics signals / Telegr diag sig

ENC, VECTOR_G Can be changed: -
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description: Displays the signals contained in the selected telegram (p7830).
Value: 0:
1:
102:
110:
111:
112:
113:
114:
115:
10500: ENC_ID_TIME_PRETRIGGER
10501: ENC_ID_TIME_SEND_TELEG_1
10502: ENC_ID_TIME_CYCLE_FINISHED
10503: ENC_ID_TIME_DELTA_FUNMAN
10504: ENC_ID_SUBTRACE_CALCTIMES
10505: ENC_ID_SYNO_PERIOD
10516: ENC_ID_ADC_TRACK_A
10517: ENC_ID_ADC_TRACK_B
10518: ENC_ID_ADC_TRACK_C
10519: ENC_ID_ADC_TRACK_D
10520: ENC_ID_ADC_TRACK_A_SAFETY
10521: ENC_ID_ADC_TRACK_B_SAFETY
10523: ENC_ID_ADC_TEMP_1
10524: ENC_ID_SUBTRACE_TRACK_A
10525: ENC_ID_SUBTRACE_TRACK_B
10526: ENC_ID_ADC_TRACK_R
10532: ENC_ID_TRACK_AB_X
10533: ENC_ID_TRACK_AB_Y
SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
Reserved
First cyclic receive telegram sensor 1
First cyclic receive telegram sensor 2
First cyclic receive telegram sensor 3
UNUSED
UNKNOWN
SAPAR_ID_DSA_ALARM
SAPAR_ALARMBITS_FLOAT_0
SAPAR_ALARMBITS_FLOAT_1
SAPAR_ALARMBITS_FLOAT_2
SAPAR_ALARMBITS_FLOAT_3
SAPAR_ALARMBITS_FLOAT_4
SAPAR_ALARMBITS_FLOAT_5
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
3
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
15157
2 Parameters
2.2 List of parameters
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
729