Panasonic KX-NSX1000 Manual page 71

–
If a call waits in a queue of an incoming call distribution group, and then the call is redirected to the
overflow destination by the Queuing Time Table. (→ 2.2.2.3 Queuing Feature)
In the above cases, the forwarding counter resets to zero, and the call can be forwarded up to four times
again from the destination extension described above.
Incoming
call
A
Original
destination
•
Boss & Secretary feature
It is possible to call the original extension from the destination extension regardless of the forward setting.
FWD—All Calls
Incoming
call
Call or
transfer a call
Boss
(Original)
•
Remote Forward setting
A flexible button customised as a Group FWD button can be used to set or unset the FWD feature for an
extension by specifying its extension number.
To allow this feature, the extension subject to this operation must specify the Remote FWD COS setting.
The authorised extension with the specified Remote FWD COS can then assign a Group FWD button to
perform remote forwarding. The forwarding status of the target extension can be checked via the LED of
the button.
Note
Pressing this button only allows the forwarding feature to be enabled or disabled. The forwarding
destination should be set at the extension subject to this operation. Also, DND cannot be enabled or
disabled.
[Example]
–
Setting Group FWD from "Secretary"
extension to "Boss" extension
If the "Secretary" (Ext. 102) presses the
assigned Group FWD button, forwarding
for the "Boss" (Ext. 101) will be turned on
(the LED will turn red).
–
Cancelling Group FWD from "Secretary"
extension to "Boss" extension
If the "Secretary" (Ext. 102) presses the
assigned Group FWD button again,
forwarding for the "Boss" (Ext. 101) will be
turned off (the LED will turn off).
1 2
B C
Secretary
(FWD destination)
3 1
D E
FWD—No Answer
DSS button
(FWD 101)
Secretary
Extn. 102
DSS button
(FWD 101)
Secretary
Extn. 102
2.3.2 Call Forwarding (FWD)
2
F
Forwarding
enabled
Boss
Extn. 101
Forwarding
disabled
Boss
Extn. 101
Feature Manual 71