5.2.6 IP-CS (KX-NS0154)
•
To enable easy setup, LLDP is supported by IP-CSs (KX-NS0154 only). If this feature causes network
congestion, it can be disabled.
•
Only KX-NS0154 IP-CSs support LAN synchronisation.
•
Even in LAN synchronisation, it is possible to also use air synchronisation. However, this is only possible
between KX-NS0154 IP-CSs.
•
You must specify a LAN synchronisation group number or an air synchronisation group number for each
IP-CS. Do not leave both of these settings unspecified.
•
In air synchronisation, if the CS loses its synchronisation signal, it will continue to run independently. Any
current calls will remain connected. Unlike previous IP-CS models (e.g., KX-NCP0158), the Watching
Degeneracy timer does not apply to the KX-NS0154 IP-CS.
PC Programming Manual References
7.4.4.1 Utility—Monitor/Trace—CS Status Monitor—Air Sync Group
7.4.4.2 Utility—Monitor/Trace—CS Status Monitor—LAN Sync Group
7.5.6 Utility—Report—IP-CS Information
9.5.1 PBX Configuration—[1-1] Configuration—Slot—Site Property—Main—Main
→ LLDP Packet Sending Ability
→ IP-CS Registration Mode
9.5.1 PBX Configuration—[1-1] Configuration—Slot—Site Property—Main—Port Number—Firmware
Update Port No. for IP-PT/IP-CS (Media Relay)
9.5.1 PBX Configuration—[1-1] Configuration—Slot—Site Property—Main—Media Relay
→ IP Extension / IP-CS—NAT - MGCP Server Port No. for IP-CS
→ IP Extension / IP-CS—Keep Alive Packet Type for IP-CS
→ IP Extension / IP-CS—NAT - FTP Server Port No.
9.19 PBX Configuration—[1-1] Configuration—Slot—V-IPCS16—Card Property
9.20 PBX Configuration—[1-1] Configuration—Slot—V-IPCS16—Port Property
10.3 PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous—Air Synchronisation—
Watching Degeneracy (x60s)
19.2 PBX Configuration—[11-2] Maintenance—CS Synchronisation
408
Feature Manual