Table of Contents
Advertisement
3.2.2 Subscriber Features
Conditions
•
If there is more than one new message in the mailbox, it can be set whether or not messages will be
played continuously without system prompts.
→ 21.1 UM Configuration—[2] Class of Service—Mailbox—Play New Messages Sequentially
PC Programming Manual References
21.1 UM Configuration—[2] Class of Service—Mailbox—Autoplay New Message
3.2.2.5 Bookmark
Description
Enables a subscriber to set one bookmark per message while pausing a message. After setting a
bookmark, a subscriber can listen to the message from that bookmark by pressing the specified key while
pausing the message or after the message was played.
Operating Manual References
Subscriber Operation
1.8.3 Message Playback and Related Features—Bookmarks (Voice Messages only)
3.2.2.6 Call-through Service
Description
Allows subscribers to make outside calls by accessing the subscriber service menu (from an outside
telephone) and dialling an outside destination. This creates a trunk-to-trunk call.
PC Programming Manual References
21.1 UM Configuration—[2] Class of Service—General
24.4 UM Configuration—[5-4] System Parameters—Parameters—Transfer to Outside—Outside Transfer
Sequence—Call Transfer to Outside Sequence (Up to 16 digits / [0-9 * # D F R T , ; N])
Feature Manual References
2.16.1 Direct Inward System Access (DISA)
Operating Manual References
Subscriber Operation
1.8.6 Other Features—Call-through Service
3.2.2.7 Call Transfer Scenario
Description
By combining the settings for Call Transfer and Incomplete Call Handling, you can create a call handling
"scenario" for your extension. Up to 20 scenarios can be created, and a scenario can be assigned to each
absent message.
PC Programming Manual References
29.1.4 My Portal—Voicemail—Advanced Call Transfer Setting
29.1.4 My Portal—Voicemail—29.1.5 Advanced Settings—Scenario Setting
292
Feature Manual
Advertisement
Table of Contents
