Panasonic KX-NSX1000 Manual page 249

When one of the devices registered to the user answers a call incoming on multiple devices, the incoming
signal on the other devices will be stopped and only the device with which was responded will be able to
speak with the outside party.
It is possible to use the rejection of incoming and Call Forward feature (Note 1) by performing the DND/FWD
settings on one of the devices owned by the user.
(Note 1) The regardless of the configured FWD type, everything operates as "FWD ALL". The operation
availability for this operation is can be selected in the System Settings. (Initial value: disabled)
[Status Display]
•
The other devices of the same user will not be able to call when one of the user's devices is on a call.
The operation criteria differ between devices on a call and devices being used. (See the table below)
Operational
telephone
Main (Off-hook)
Sub (Off-hook)
Wireless (Off-
hook)
Cellular (Outgoing
calls via DISA)
DSS
•
The user status can be displayed by assigning the user's extension code to the DSS.
–
When the user's main device is serviced in and the user status is on Idle (DND settings excluded), the
light of the DSS button is off.
The configured user can receive calls by pressing the DSS button when the light is off.
–
The DSS button is flashing red during in an incoming call state supporting proxy response, and is lit red
during an incoming call state which does not support proxy response.
The call can be accepted by pressing the red flashing DSS key.
For information about the incoming call types supporting Proxy response, see "2.4.3 Call Pickup".
For information about the LED flash patterns, see "2.21.3 LED Indication".
–
The DSS button will light up red when the user enters one of the following states.
1.
When the user inactive (including when the User Container is not created)
2.
When the user's main device is serviced out
3.
When one of the devices of the user is busy on a call
4.
When a user has DND enabled
5.
When in an incoming call state that does not support Proxy response
PC Programming Manual References
8.1.1 Users—User Container—Add User/Edit User
Main
- Call interception
Call interception -
Call interception Call interception
Busy tone played Busy tone played
after pressing after pressing
Dial after hearing Dial after hearing
the DT the DT
Busy telephone
Sub Wireless
Call interception
Call interception
-
Busy tone played
after pressing
Dial after hearing
the DT
2.29.2 Call Control Feature
Cellular
Busy tone played after
pressing Dial after
hearing the DT
Busy tone played after
pressing Dial after
hearing the DT
Busy tone played after
pressing Dial after
hearing the DT
Busy tone played after
pressing Dial after
hearing the DT
Feature Manual 249