Table of Contents
Advertisement
1) Extn. 105 dialled
PBX A in Office A
Extn. 101
Extn. 103
Extn. 104
Explanation:
In the same way as when connected by a TIE Line, if a dialled number is not found at the local PBX, the call
can be sent to other PBXs connected via an IP network. When an extension number is dialled, the PBX first
searches local extensions for a matching number. If there is no match, the PBX then checks the TIE Line
Routing Table for the Gateway Group for a corresponding entry. If an entry is found, the call is sent to the
connected PBX.
Conditions
•
System programming is required to enable this feature.
•
If the called extension does not exist at the called PBX, the next PBX in the same gateway group is called
automatically.
•
The Routing to Operator setting in system programming must be disabled to use this feature.
•
To use this feature, all PBXs in the IP network must be KX-NS1000 PBXs, or KX-NCP/KX-TDE series
PBXs with MPR Software Version 3.0000 or later.
PC Programming Manual References
18.5 PBX Configuration—[10-5] CO & Incoming Call—Miscellaneous—Intercept—Routing to Operator - No
Destination (Destination is not programmed.)
4.3.2.3 Call Distribution Port Group
Description
It is possible to set which virtual port receives each call depending on the telephone number of the called
party.
By assigning each port to a Call Distribution Port Group (CDPG), it is possible to select which group
receives each call. CDPG settings cover all V-IPGW cards in the PBX, which allows for ports on different
cards to be assigned to the same CDPG. In other words, two 8-port cards can be used as one 16-port card.
Programming Example:
To enable this feature, it is necessary to programme the following 2 tables through system programming:
•
CDPG Table
Private IP
V-IPGW
Network
4) Check next PBX in
Gateway Group settings
4.3.2 Voice over Internet Protocol (VoIP) Network
2) Extn. 105 not
found in PBX B
V-IPGW
3) Rerouted
V-IPGW
PBX B in Office B
Extn. 102
Extn. 202
Extn. 203
PBX C in Office C
Extn. 105
Extn. 201
Extn. 303
5) Extn. 105
found in PBX C
Feature Manual
367
Advertisement
Table of Contents
