•
Sub devices operate based on the COS of the main device and/or the settings of each terminal. Key
settings (including PF key (One dial) and LCD data of self-labeling), or, specified priority calling/
specified wired calling also follow the device settings in main.
Conditions
•
The paging signal cannot be delivered on SIP or SLT type terminals.
•
Voice calls can only be made by main extensions that use PT.
•
The settings of the main device are obeyed when receiving a call when already on a call. At this time the
incoming call is only displayed on the main device, however, by disconnecting the incoming call, the call
will be displayed on all the devices as configured in the delay settings. However, the call will immediately
arrive on the terminal on a call without applying the delay settings.
•
It is not possible to directly call the extension number of the sub-extension with CTI control.
•
Calls cannot be intercepted with another device if the calling device is in any of the following states.
–
During extension DT heard, extension dialing, outside line DT hearing, outside line dialing
–
During consultation hold
–
During conference calls (can be used during 2 way recording)
•
The settings per device listed below, operate based on the settings of the main extension/sub extension.
–
On/Off of the BGM status
–
LCS On/Off (when the main extension and sub extension both are on LCS-On "Private Mode" the LCS
incoming calls will be performed prioritizing the main extension)
–
Auto Answer Switching (switching by using the AUTO key of the PT)
PC Programming Manual References
8.1.1 Users—User Container—Add User/Edit User
2.29.2.3 DSS Console
Description
The DSS console can be used with the sub devices configured in the User Container.
Conditions
The pair extension numbers of the DSS console can only be configured by the number of the main device
(=extension number of the user).
Extensions with DSS can not Service-out.
PC Programming Manual References
10.9 PBX Configuration—[2-9] System—System Options—Option 4—DSS Key—DSS key mode for
Incoming Call
2.29.2.4 Wireless Device
Description
By calling the user's main device, it is possible to simultaneously send an incoming call signal to the
wireless devices that are registered in the User Container.
1.
Outgoing call
2.29.2 Call Control Feature
Feature Manual
251