2.1.1 Incoming Trunk Call Features
Note
The following settings can also be specified in the DIL table:
•
Tenant number: determines the time mode (day/lunch/break/night) for the corresponding trunk.
•
UM service group number: determines the service group to use when a call is handled by the Unified
Messaging system.
Explanation:
If a trunk call is received from trunk 01;
In Day mode: CLI is enabled. Route to CLI destination.
In Lunch mode: CLI is disabled. Route to DIL destination, extension 100.
PC Programming Manual References
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings—DIL
→ DIL Destination—Day, Lunch, Break, Night
→ Tenant Number
→ UM Service Group No.
Feature Manual References
2.1.1.5 Calling Line Identification (CLI) Distribution
3.2.1.40 Service Group
5.1.3 Tenant Service
5.1.4 Time Service
6.1 Capacity of System Resources
2.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
Description
Provides automatic direction of an incoming call with a DID/DDI number to a preprogrammed destination.
Each DID/DDI number has a destination for each time mode (day/lunch/break/night).
Incoming calls with DID/DDI numbers that match extension numbers at this PBX will be sent to the
corresponding extension. Incoming calls with DID/DDI numbers that match extensions at other PBXs or
trunk access numbers will be sent to the corresponding TIE line or trunk.
26
Feature Manual