Table of Contents
Advertisement
2.29.2 Call Control Feature
•
The operations performed from a wireless device are treated as operations performed from a main
device.
The information shown when making a call from a wireless device (extension number/extension
name, caller number/caller name) is in accordance with the user's caller information.
2.
Incoming call
•
By calling the user's main device, the wireless devices that are registered to the User Container will
also ring.
Voice-based calls are also possible for the wireless device.
•
It is possible to send an incoming call signal to a main device at a predetermined time delay from the
time of an incoming call to the main device.
The delay time can be configured for each device (you can choose from immediately, 5 seconds, 10
seconds, and 15 seconds).
[Parallel connect Mode]
–
Parallel connect Incoming call mode can be turned ON/OFF by use of the Access Codes. (Initial
value: ON)
(Mode setup method) Put the handset off hook and dial the Parallel connection access code + 1
(ON)/0 (OFF).
3.
Call
[Call interception between user devices]
–
It is possible to forward incoming calls to other devices (operation terminal), by having another
device performing one of the operations listed below, if any of the main/sub-/wireless devices
(except general purpose SIP terminals) is on a call. (Call interception)
•
Handset is off hook during standby.
•
Press [SP-Phone][Monitor] during standby.
* The conditions are listed in the section <Call interception between user devices> of "Sub devices".
[Call waiting]
–
Sound during a call (call waiting tone / hold alarm, etc.) is carried out only for the person on a call.
–
DSS button for public devices
The DSS button light of the extension registered first in an ICD Group will turn red when the
public device:
•
is on a trunk call that was received via the ICD Group.
•
is on a trunk call that was made using the Walking COS Through DISA feature. (→
2.16.1 Direct Inward System Access (DISA))
Conditions
•
The call doesn't arrive on the extension number of the wireless device.
•
If Parallel Connection Call Mode is switched OFF, calls cannot be received on wireless devices.
However, although the incoming call is not displayed, it operates the same as your own extension during
a Non-parallel Connection. (Example) Calls are answered by performing the response operation.
PC Programming Manual References
8.1.1 Users—User Container—Add User/Edit User
252
Feature Manual
Advertisement
Table of Contents
