Table of Contents
Advertisement
2.29.2 Call Control Feature
2.29.2.2 Sub Device
Description
1.
Standby
•
The display during standby mode shows the main extension number.
2.
Outbound call
•
Operations performed from a sub device are treated as if performed from the main device.
3.
Inbound call
[Paralell ringing]
–
Calls to the user also arrive on the sub devices.
–
The main extension number/extension name of the user is displayed on the extension display of the
calling party during an extension call to a sub device.
–
The paging signal will be delivered to all extensions, the main extension, sub-extensions and PSs.
However, the paging signal cannot be delivered on SIP or SLT type terminals.
–
LCS calls operate according to the settings of the main extension or sub extension that uses PT.
However, when the LCS call is set arrive to whichever extension, the main extension will be
prioritized.
–
It is possible to send an incoming call signal to a sub device at a predetermined time delay from the
time of an incoming call to the main device.
The delay time can be configured for each device (you can choose from immediately, 5 seconds, 10
seconds, and 15 seconds).
–
When the incoming call to the main device is stopped by the receiver modification feature, the
incoming call to the sub devices, wireless devices, and public devices will also be stopped.
–
Recalls for the terminal handling such as, pending recalls and callbacks only arrive on the operation
device.
Transferred recalls arrive on the transfer recall destination extension as configured in the main
extension.
4.
Call
[Call interception between user devices]
–
It is possible to forward incoming calls to other devices (operation terminal), by having any of the
main/sub-/wireless devices (except general purpose SIP terminals) performing one of the following
operations. (Call interception)
•
Handset is off hook during standby.
•
Press [SP-Phone] [Monitor] during standby.
–
It is possible to intercept calls from general-purpose SIP terminals by using the Access Code
operation.
At this time, the caller will be placed on hold for a short while after which he/she will be connected to
the device that intercepted the call.
The Access Code operation can specify the main extension number of the user by use of the
Extension specified proxy response operation or the Simple proxy response operation.
[Call waiting]
–
Sounds heard during a call (such as call waiting tones and hold alarms), are only sent to the party
that is on the call.
[Setting data between devices]
250
Feature Manual
Advertisement
Table of Contents
