Table of Contents
Advertisement
•
Calls can be made to a public device (up to 4 devices) registered in the User Container by calling to
the extension number registered to that Container.
The outside line is acquired through the outside line acquisition method registered in the User
Container, and automatically calls the relevant public device.
It is possible to send an incoming call signal to each public device, at a predetermined time delay
from the time of an incoming call to the main device. The delay time can be configured for each
device. (you can choose from immediately, 5 seconds, 10 seconds, and 15 seconds)
•
When delayed a call is received on the public device you can select whether or not to stop the
incoming of the call to the main device, sub device and wireless device.
The settings are enabled if there is even a single public device of which the delay time is set to
anything other than immediate, the main devices, sub devices and wireless devices will stop
receiving calls at the timing when delayed ringing is triggered. (In case multiple public devices have
the delayed call setting configured, the settings will become active at the first ring.)
2.
During a Call
[Transfer Call After Answering]
•
You can transfer a call from devices such as a cellular device to other extensions when responding
to a call received via the PBX on an outside line.
This feature can only be used from a mobile device (public) linked to the User Container.
•
The call is treated the same as when "Hooking" from an SLT extension of an SLT extension call by
the "#" sent to the PBX outside line from the cellular device during a call.
•
The outside line of the other party can temporarily be put on hold, and depending on the dial
operation after put on hold an extension can be called or the call can be transferred to an extension.
The outside line performing the temporary hold action will hear the 1A dial tone, the side being put
on temporary hold will hear the hold tone just like when a normal extension would be put on hold.
(the tone will stop playing when a number is dialed)
•
When the "outside line - propriety of the transfer of calls originating from an outside line" setting of
the System Unit is set at "Disable", the "# of DTMF" will be disabled without starting temporary hold.
Outside line (Enabled as the "DTMF" of call delay) - Only when using an outside line <Optional
Device – Voice Message – DISA System – CO_CO With DISA>
•
Call restriction, and the connection regulations are applied to the transfer destination, following the
COS information configured by the user of the cellular device.
All the extension types are suitable as a destination extension.
[Call interception]
PSTN
101
102
2.29.2 Call Control Feature
Mobile network
DTMF
#101
Transfers to extension
101 by entering
DTMF "#101"
Feature Manual
255
Advertisement
Table of Contents
