Switch Port Commands - D-Link DGS-3212SR Command Line Interface Reference Manual

The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config ports
show ports
Each command is listed, in detail, in the following sections.
config ports
Purpose
Syntax
Description
Parameters
DGS-3212SR Layer 3 Gigabit Switch
Parameters
[ <portlist>| all ] { speed [auto | 10_half | 10_full | 100_half |
100_full | 1000_full {[master | slave]} ] | flow_control [enable |
disable]|learning [enable | disable ] | state [enable | disable] |
description [ <desc 32> | clear ] }
{<portlist>} {description}
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to configure the Switch's Ethernet port settings.
[ <portlist>| all ] { speed [auto | 10_half | 10_full | 100_half |
100_full | 1000_full {[master | slave]} ] | flow_control [enable |
disable] | learning [enable | disable ] | state [enable | disable] |
description [ <desc 32> | clear ] }
This command allows for the configuration of the switch's Ethernet
ports. Only the ports listed in the <portlist> will be affected.
<portlist> − Specifies a range of ports to be configured. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
all − Configure all ports on the switch.
auto − Enables auto-negotiation for the specified range of ports.
[10 | 100 | 1000] − Configures the speed in Mbps for the specified
range of ports.
[half| full] − Configures the specified range of ports as either full-
or half-duplex.
S
WITCH
25
5
P C
ORT OMMANDS