Grain Weight Calibration - Ag Leader Integra Display Operator's Manual

Create a new Field Operation Configuration.
After you have completed the grain weight calibration and a new calibration factor has been calculated in
the CEBIS monitor, this new calibration is then sent to the display. The display then uses the new
calibration to update all data collected since the time it detected the start of the new calibration. No
further messages appear in the display.
Note: The New Grain Calibration warning does not appear for the first calibration performed during the
season. It only appears for calibrations performed thereafter.
Note: The display does not update any previously-collected data collected prior to the time it detected the
start of the new calibration.
Manual Moisture Setting
As with other calibration information, the Moisture Calibration is calculated in the CEBIS monitor and
then relayed to the display. However, you can adjust moisture settings for a specific region with the
display's Use Manual Moisture setting. The manual moisture setting will only be applied to the specified
region.
Grain Calibration
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > your
specific configuration > Setup (wrench) button > Grain Calibration button
Lexion Calibration
Moisture
Calibrations
15.0 %
Use Manual Moisture
Note: The list shown in the CLAAS Calibration screen only shows loads harvested during the current season.
Ag Leader PN 4002083 Rev. N
Your Specific
Configuration
Configuration
The CLAAS Calibration screen appears.
Use Manual
1. Check
Moisture
2. Use
Moisture to the desired value. Press
finished.
H
.
/ to adjust the Manual
ARVEST
when
349