Run Time Operations - Ag Leader Integra Display Operator's Manual

Press to turn spinners on and clear warning dialog. Press
and clear warning dialog.
S S
PINNER
CONFIGURATION
• Spreader Control button
Displays the status of the product control channel. The Conveyor Speed (in RPM) is shown underneath the
bin icon; the Spinner Speed (also in RPM) is shown at bottom. Press the Spreader Control button to display
the Spreader Control screen and settings. These settings include Spread Width, Spinner Speed (if enabled),
Product Density, Feed Gate Opening, and Conveyor Rate. For more information, see section beginning at
"Spreader Control screen" on page 303
• Conveyor Indicator
The Conveyor Indicator is shown at the bottom of the Product Control toolbox when the Map screen is
shown in Zoom to Extent. When the Map screen is shown in the Zoom to Details view or Perspective View,
the conveyor indicator is shown as a bar that appears behind the vehicle icon.
R T O
UN IME PERATIONS
During Run Time Operations, Spinner Spreader operators can press the Spreader
1
2
Control button to open the Spreader Control screen. At this screen, you can adjust
700 25 25
Spread Width, Spinner Speed, Product Density and other settings.
RPM
• Each of these settings described below must be set for each individual Product Channel (bin).
• Changed settings do not take effect until verified. However, if your machine is equipped with Fan Frame
& Feed Gate Actuators, and you have also purchased a New Leader Linear Actuator unlock code, the
settings on the spinner bed will change automatically.
• The Spread Width, Spinner Speed, Product Density, Feed Gate 1 Opening and the Conveyor 1 Rate
are all stored with each combination of product and control channel.
Spreader Control screen
Spreader Control
Spread Width
Channel 1
Channel 2
60 ft
DAP
Spinner Speed
Product
600 rpm
Feed Gate 1
Conveyor 1
Chain
Static
In-Field
• Product Density
This density value (shown in pounds per cubic foot, or lb./ft.3), is stored with each product. Press
to edit if needed.
Ag Leader PN 4002083 Rev. N
,
PREADER WITH TWO
.
3
58 lb/ft
2 in
3
0.256 ft /rev
-
BIN
• Spread Width
Press to edit the value.
• Spinner Speed
The spinner speed required for accurate product
placement in relation to the spread width setting.
- The spinner speed is controlled automatically based upon
this setting when the system uses an optional PWM
spinner speed control valve.
- To accurately determine Spinner Speed settings you
should perform a spread pattern catch test. See
Control: Static Calibration" on page
A
PPLICATION
to keep spinners from running
"Spreader
306.
303