• Fast Restart
Checking this box before the vehicle is shut down allows the receiver to utilize shutdown time to acquire the
appropriate satellites in order to ensure a quick and efficient startup. This reduces the time taken for satellite
convergence after startup, and thus increases accuracy in the field.
Note: To get the most benefit from Fast Restart, you should shut down the vehicle in a place where the
receiver has a clear view of the sky. Do not move the vehicle before powering up again.
• GGA (GLONASS)
Checking this box allows the additional GLONASS satellites to be displayed in the GGA message.
• AutoTune Frequency check box
Receiver will automatically select the strongest frequency.
• Frequency
In the Frequency drop-down list box, select the geographic region where you are located. If you wish to
enter a Custom Frequency, select Custom. Then enter the frequency number in the text box below.
Note: The display does not come with custom frequency numbers. Enter a number only if directed to by
OmniSTAR.
• Baud Rate
The baud rate represents the speed at which your receiver obtains information from the satellite.
Note: You should always keep the baud rate set at 1200 unless directed by OmniSTAR or Technical Support.
• Convergence Threshold
The receiver uses the standard deviation of the solution to determine when the OmniSTAR position has
converged. The receiver will label the OmniSTAR solution as "converged" when the horizontal standard
deviation reaches the Convergence Threshold setting. Relaxing the convergence threshold shortens the
time before a OmniSTAR solution is reported as converged. However, it does not alter the absolute
behavior of the solution.
GPS I
NFORMATION FOR
GPS2500
Press: GPS (satellite) button
120
2500 RTK
Firmware Version 6.0
Need help?
Do you have a question about the Integra Display and is the answer not in the manual?