Setup Down Force Configuration - Ag Leader Integra Display Operator's Manual

Operating Configuration Wizard: Down Force Options
Down Force Configuration
2 Channel, 4 Sensor
Channel Sensor
1 1
1 2
1 3
1
4
2 1
2 2
2 3
2 4
S D
ETUP OWN
Down
Force
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > your
specific configuration > Setup (wrench) button > Down Force button
Down Force
Channel 2
General Channel 1
Down Force Mode Gauge Wheel Sensor
Control John Deere
Control Settings Uplift Force
Automatic Hold
Maximum Force
Hydraulic Pressure To
Down Force Conversion
6.24 PSI/lb
Down Force Mode
• Monitor Only (default)
- Allows user to monitor the weight on the gauge wheels but does not adjust down pressure.
- Control Settings (Automatic Hold and Hydraulic Pressure to Down Force Conversion) are grayed out
when using Monitor Only mode.
• Control
- Allows user to monitor the weight on the gauge wheels and have system automatically adjust down
force.
Automatic Hold: a feature which holds down force at last know force per channel when AutoSwath
turns off a section.
188
Row
2
7
18
23
11
12
13
14
F C
ORCE
Configuration
Gauge Wheel Load Alarm
Minimum Load
20 lb
Time Threshold
0 lb
3 s
448.79 lb
At the Down Force Options screen, the operator can
choose a Down Force configuration from the drop
down menu:
The rows listed are the recommended rows where the
sensors should be installed.
The operator can assign rows if custom installed.
Row 1 is the on the left side of the planter (when
standing behind the planter facing forward).
ONFIGURATION
Select Your Specific
Configuration
Down Force screen General tab
Firmware Version 6.0