Table of Contents
Advertisement
CAUTION: For proper machine performance and accuracy, Product Density should be measured for every
application load.
Conveyor Rate
Conveyor 1 Rate
3
O ft
Conveyor Rates for Products Previously Applied
Product
Potash
MAP
Fan Frame & Feed Gate Actuator Settings
These are optional settings used by operators using a New Leader Linear Actuator module.
• Fan Frame
Checking the Fan Frame check box enables the Fan Frame Actuator. Displays the distance between the
spinner bed and the spinner assembly. Press
• Feed Gate
Checking the Feed Gate check box enables the Feed Gate Actuator.
Spreader Control: Routine Operations
The Spreader Control screen has three buttons, Chain Oiler, Static Calibration and In-Field Calibration,
which are described below and on the following pages.
Spreader Control: Chain Oiler
If you are using a Chain Oiler, you can automatically perform a chain oiling routine by pressing the Chain
Oiler button on the Spreader Control screen and following the steps below.
Note: Perform a chain oiling routine daily.
1. Press Spreader Control button
1
2
700
25
25
RPM
2. Acknowledge the first warning
Manually disable or shut off the spinner hydraulic circuit.
3. Enter a Routine Duration
Enter the routine time that it takes to turn the conveyor one revolution.
4. Press Start
Press the Start button, and when the routine is finished press
5. Acknowledge the second warning.
Return the spinner hydraulic control to a field-ready condition.
Ag Leader PN 4002083 Rev. N
The Conveyor Rate button opens a setup screen where the
conveyor rate can be inputted and a table of previously
applied products and conveyor rates is shown.
/rev
3
Press the conveyor rate button and press
ft
/rev
0.2560
desired conveyor rate.
0.0000
Press
the Spreader Control window.
To begin, press the Spreader Control button to open the Spreader Control screen. At
the Spreader Control screen, press the Chain Oiler button.
to accept the new conveyor rate and return to
to edit this value.
.
A
PPLICATION
to input
305
- Quick Links:
- Display
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Integra Display and is the answer not in the manual?
Questions and answers
When planting with row shutoffs, and I start overlapping, my rows start to shutoff. When this happens the screen starts to alert and then throws up a check mark that I have to hit each time that I have to hit to get back to my mapping page. Is there away I can do away with this process and just have it alert me that the rows are shutting off