Table of Contents
Advertisement
G
UIDANCE
O
T
N
RAC
To ensure proper AutoSteer Operation make sure your GPS source is setup properly.
Complete the following steps to access AutoSteer setup screen:
3. Press: Home button > Setup (wrench) button > GPS Guidance button > OnTrac2 Steering drop-down
> Setup (wrench) button
A
S
UTO
TEER
AutoSteer Setup
System
GPS
My Account
Vehicle
Manage
Setup Wizard
Auto Calibrate
Vehicle
Steering
Steering
Adjust
Components
configure a vehicle, set up a new vehicle, manage existing vehicles, perform the auto
calibration of a vehicle, perform the steering adjustments, and manage steering
Vehicle
components.
configure and monitor system parameters.
System
status of your GPS corrections. For more information, refer to the Display or GPS operators
manual.
GPS
configure and monitor account parameters.
My Account
Ag Leader PN 4002083 Rev. N
2+
Guidance/Steering
OnTrac 2 Steering
S
S
ETUP
CREEN
All instructions for the calibration and setup of the OnTrac2+ start
from the AutoSteer Setup screen.
<<<Instructions start from this screen
The AutoSteer Setup screen gives you access to the following
functions:
1. Start the Display.
2. Turn on the Mechanical Drive Unit (MDU) with
On/Off switch (A).
G
UIDANCE
143
- Quick Links:
- Display
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Integra Display and is the answer not in the manual?
Questions and answers
When planting with row shutoffs, and I start overlapping, my rows start to shutoff. When this happens the screen starts to alert and then throws up a check mark that I have to hit each time that I have to hit to get back to my mapping page. Is there away I can do away with this process and just have it alert me that the rows are shutting off