Kinze Planter Monitor Module; Kinze Planter Configuration - Ag Leader Integra Display Operator's Manual

P
LANTING
KINZE P
M
ODULE
The KINZE Planter Monitor Module is a feature that displays planting data from a KINZE Population
Monitor on the Map screen.
Note: Steps 1-4 must be performed by everyone who has purchased a KINZE Planter Monitor; steps 5-6 are
performed by customers who have purchased those specific features.
1. KINZE Planter Monitor Module Configuration
This creates a configuration that is used for KINZE Planter Monitor operations.
2. Monitor Module setup
Included front and rear unit settings, Shaft RPM sensor settings, and row spacing settings. This step allows
the display to detect the physical KINZE Planter devices.
3. Sensor detection process
This allows the display to detect the proper number of muxbus sensors on the row units. For more
information, see
"Muxbus Sensor Detection" on page 211
4. Set alarm thresholds
This allows user-defined level at which the seed monitor alarms will sound. For more information, see
"Alarms on KINZE Planter Monitor" on page 219
5. Calibrate the Magnetic Pickup Coil
This step, which is performed by customers who have purchased the Magnetic Pickup Coil Speed Sensor
allows the Monitor Module to receive data from this sensor, which measures the ground speed of the
planter. For more information, see
6. EdgeVac® calibration
This step, which is performed by customers who have purchased the EdgeVac® seed meters, allows the
display to receive accurate data from the meters. For more information, see
.
on page 215

KINZE Planter Configuration

Seed Monitor
Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > your
specific configuration > Setup (wrench) button > Seed Monitor button > Planter Configuration button
Ag Leader PN 4002083 Rev. N
LANTER
.
"KINZE Magnetic Coil Speed Sensor Calibration" on page 214
Configuration
Planter Configuration
M
ONITOR
.
"KINZE EdgeVac Calibration"
Select Your Specific
Configuration
P
LANTING
.
209