Table of Contents
Advertisement
D
IAGNOSTICS
266
Warning Enabled – With this setting enabled, the user
will get a "Rate Not Responding" alarm when the
actual rate does not fall within the threshold and
timeout settings. The user will not receive an alarm if
this setting is disabled.
Rate Not Responding Threshold – This setting
defines the percent value the actual rate can be off
from the target rate and not trigger the "Rate Not
Responding Alarm" alarm.
Rate Not Responding Timeout – This setting defines
the amount of time the actual rate can fall outside the
Rate Not Responding Threshold without triggering the
"Rate Not Responding Alarm" alarm.
Press Diagnostics button.
Module Diagnostics – Contains module
diagnostic information to assist in troubleshooting.
Alarms – Contains any active alarms from the
module.
Firmware Version 6.0
- Quick Links:
- Display
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Integra Display and is the answer not in the manual?
Questions and answers
When planting with row shutoffs, and I start overlapping, my rows start to shutoff. When this happens the screen starts to alert and then throws up a check mark that I have to hit each time that I have to hit to get back to my mapping page. Is there away I can do away with this process and just have it alert me that the rows are shutting off