Operator Log Out; Configuration Setup Screen - Ag Leader Integra Display Operator's Manual

Operator Selection
Select Operator
Eilers, George
Options
Show Operator Selection on Startup
Note: If the active operator has a password, the
operator selection will always be displayed on startup.
O L
PERATOR OG
Log Out
Press: Home button > Operator: button > Logout button
Users that are both a Manager and Operator can logout which locks Setup and USB access and an
operator must log in before an operation can be performed.
C
ONFIGURATION
Guidance
The Configuration Setup screen is where you can make settings adjustments for your equipment,
ground speed, GPS, and controllers.
The appearance of this Configuration Setup screen varies, based on your particular configuration. Some
DirectCommand and SeedCommand configurations include settings that are mentioned in those
individual chapters. Most Configuration Settings screens will include the following buttons.
• Equipment Settings. For more information, see
• Speed Input. For more information, see
• AutoSwath. For more information, see
• GPS Offsets. For more information, see
• Swath Section Offsets. For more information, see
• Controller Settings. For more information, see information in the SeedCommand and DirectCommand
chapters.
• Calibrate Pressure. Used in DirectCommand Liquid Application configurations.
44
O
UT
S
ETUP
"Speed Input Settings" on page 80.
"AutoSwath" on page 84
"Vehicle Offsets" on page 85
2. Choose the operator from drop-down menu.
Note: Checkbox will require a password to be
entered upon start up of the display.
Press .
3. Enter password. Press
The operator will now be selected and permissions
active
S
CREEN
"Equipment Settings" on page 79
.
.
"Swath Section Offsets" on page 86
.
.
.
Firmware Version 6.0