Table of Contents
Advertisement
C
ONTROLLER
Controller Settings
226
S
ETTINGS
Implement Offsets screen appears, with each
channel's settings shown on its own tab.
Defaults to the value entered during Configuration
Wizard
Boom sections can independently be offset forward
or back (application only)
Press
Offsets screen.
Select Swath section to edit and press Edit button.
Enter Offset for that specific section and
Forward/Backward from rear axle.
Press
Setup will indicate which offset is entered
same offset)
has a different offset)
Runscreen reflects section offsets
Select Your Specific
Configuration
Configuration
to access Swath Section
to enter change.
Global (All sections have the
Individual (At least one section
Firmware Version 6.0
- Quick Links:
- Display
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Integra Display and is the answer not in the manual?
Questions and answers
When planting with row shutoffs, and I start overlapping, my rows start to shutoff. When this happens the screen starts to alert and then throws up a check mark that I have to hit each time that I have to hit to get back to my mapping page. Is there away I can do away with this process and just have it alert me that the rows are shutting off