Row Shutoff; Configuration Setup; Row Shutoff Look-Ahead Numbers - Ag Leader Integra Display Operator's Manual

Ag leader integra display
Table of Contents

Advertisement

P
LANTING
A
S
UTO
WATH
R
S
OW
HUTOFF
Create an Implement configuration with Row Shutoff by following the procedure in
Configuration" on page 161
and control planter sections row-by-row, allowing AutoSwath Control to automatically turn planter row
units on and off based on your planting map.
See
"Map Options" on page 51
C
ONFIGURATION
Once the configuration is created and it appears on the Configuration Setup screen, AutoSwath should
be configured correctly. However, if you cannot get the configuration to load on the Field Operation
Wizard, or if your vehicle does not appear on the Map screen, you may wish to check if the row clutches
have been correctly set up in Implement Setup. Use the following procedure to enable Seed Row Shutoff
and/or configure the Clutch Module.

Row Shutoff

Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > your
specific configuration > Setup (wrench) button > Row Shutoff button
The Row Shutoff Module Configuration screen appears. This screen shows the number of Row Shutoff
Modules and the sections that each module controls.
R
S
OW
HUTOFF
This table references the Turn-On Look-Ahead and Turn-Off Look-Ahead numbers for both Electric
Clutch and Air Row Shutoff Modules.
Planter Unit Seed Meter Type
Finger Units
Vacuum
Note: Using the above settings should produce good field results. However, always take the time to check for
proper seed placement in the field and make system setting adjustments as needed. Do not rely solely upon
the appearance of the On-Screen map. The on screen map will not show gaps and overlaps caused by
incorrect GPS Offsets or AutoSwath Look-Ahead settings.
Ag Leader PN 4002083 Rev. N
. By configuring your display with Row Shutoff, you can start and stop seed flow
for more information on using reference maps for AutoSwath.
S
ETUP
Configuration
L
-A
N
OOK
HEAD
Select Your Specific
Configuration
UMBERS
On/Off
Electric Clutch
Turn On
0.9
Turn Off
0.3
Turn On
0.9
Turn Off
0.4
P
LANTING
"Create Planting
Air Clutch
1.1
0.3
1.1
0.4
165

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Integra Display and is the answer not in the manual?

Questions and answers

Mark Wenzl
May 8, 2025

When planting with row shutoffs, and I start overlapping, my rows start to shutoff. When this happens the screen starts to alert and then throws up a check mark that I have to hit each time that I have to hit to get back to my mapping page. Is there away I can do away with this process and just have it alert me that the rows are shutting off

Table of Contents

Save PDF