Ag Leader Integra Display Operator's Manual page 310

6. Select Controller Device
Select DirectCommand from the Device drop-down menu. Select either, Spinner Spreader Control 3CH,
5CH, or Stepper Spreader Control from the Direct Type drop-down menu. Press
7. Enter Controller Name
Controller name defaults to DirectSpreader. Press
name if desired. Press
8. Container Setup
Press the desired channel button to enable or disable controller channel. A check mark will appear in the
box when the container is ready to be configured.
9. Assign Container Name
Container names default to "Bin 1-5"depending on which granular control module is being used. Press
to enter a new name if desired.
10. Assign Container Capacity
Press to enter the container capacity. Press
11. Enter Container Units
Use the drop-down menu to select the container units.
Once container has been configured press
Follow steps 9-12 for each control channel.
Note:
12. Enter Application Point Offset
Press to enter distance from hitch to application point (front to back). Press
value on offset screen. Press
If setting up a Self-Propelled Applicator, enter the distance from rear axle to application point.
Note:
Use drop-down menu to select distance Behind or In Front.
At this point additional functionality can be added to the implement. If no additional
Note:
functionality is being added, press
13. Add Additional Devices (optional)
Press
OptRx Crop Sensor
• Press to enter sensing width (defaults to implement width, change only if necessary).
• Use /
294
to continue.
to accept value for the application point.
to add boom sensor functionality.
to enter number of sensors.
to accept, or press
to accept.
to continue.
to continue.
to continue.
to enter a new
to accept
Firmware Version 6.0