Default Redistribute Cost; Default Redistribute Interval - Accton Technology ES4626 Management Manual

router ospf
stub cost
virtuallink neighborid
show ip ospf
show ip ospfase
show ip ospf cumulative
show ip ospf database
show ip ospf interface
show ip ospf neighbor
show ip ospf routing
show ip ospf virtual-links
show ip protocols
debug ip ospf event
debug ip ospf lsa
debug ip ospf packet
debug ip ospf spf
15.4.2.2.1

default redistribute cost

Command: default redistribute cost <cost>
no default redistribute cost
Function: Sets the default cost for introducing exterior routes into OSPF; the "no default
redistribute cost" command restores the default setting.
Parameter: < cost> is the route cost, ranging from 1 to 65535.
Default: The default introducing cost is 1.
Command Mode: OSPF protocol configuration mode
Usage Guide: When OSPF routing protocol introduce the routes discovered by the other
routing protocols, those routes are regarded as the exterior autonomous system routing
information. Introduction of exterior routing information requires some external parameter
such as default cost and default tag for the routes. This command allow the user to set
reasonable default cost for introducing exterior routes according to specific conditions,
Example: Set the default cost for OSPF to introduce exterior routes to 20.
Switch(Config-Router-Ospf)#default redistribute cost 20
15.4.2.2.2

default redistribute interval

Command: default redistribute interval <time>
no default redistribute interval
Function: Set the interval for introducing external routes; the "no default redistribute
interval" command restores the default setting.
Parameter: <time> is the interval for introducing exterior routes in seconds; the valid
range is 1 to 65535.
397