Stiffness Menu; Thickness Menu; Heater Menu - Oce CS9090 User Manual

Chapter 5: Handling the printer

5.4.1.10 Stiffness menu

Set the media sticking force (media stiffness) to the media guide.
Setup items Parameters
Stiff <Normal>
Soft
-

5.4.1.11 Thickness menu

Set the media thickness.
Setup items Parameters
Thickness 50µm-<100µm>1500µm
Notes
Bidirectional quality can only be obtained when media thickness is set correctly

5.4.1.12 Heater menu

Set the temperature of the Heater.
Setup items Parameters
Heater OFF – 50°C
Notes
•
The default setting for the heater is set to '50°C'.
•
The function of the heater (A): Warming the transfer paper before entering the pressure rollers. The
pre-expansion helps to minimize media cockling.
AP-75036 - Revision 1.3 – 20/03/06
Description
Setting for normal media
Setting for soft media where media feeding errors
and media jams occur
After setting, shift to the previous hierarchy menu.
Description
Change media thickness by operating the following keys.
• [F2] key: to increase the setup value.
• [F4] key: to decrease the setup value.
• [ENTER] key: to confirm the setup value
• [CANCEL] key: to cancel the setup value
Description
Change heater temperature by operating the following keys.
• [F2] key: to increase the setup value.
• [F4] key: to decrease the setup value.
• [ENTER] key: to confirm the setup value
• [CANCEL] key: to cancel the setup value
90 User's Guide CS9000 series