Setting Media Type - Oce CS9160 User Manual

4.3.3 Setting media type

Introduction:
When you have loaded the media in the CS9160, you will have to set the media type. The Media setup menu
is displayed after the media hold lever is pushed from the backward position to the forward position. (= lever
down)
Notes
• The printer starts the media initialization without setting the media type when
• The [Cancel] key of the operation panel is pressed.
•
No key operations are performed on the operation panel for 10 seconds.
Step 1 : Verify that the printer has been switched ON, and the media has been loaded.
Result: After the media is loaded, the display shifts to the Media setup menu.
Notes
•
Refer to the following topics to load media:
•
Installing roll media
•
Loading roll media
Step 2 : Press the [Setting value +] key or [Setting value-] key to select the correct media type.
Step 3 : Press the [Enter] key to confirm your choice.
Result:
•
The media type is determined
•
The operation panel displays "Media Initial", and the media initialisation starts.
Step 4 : After media initialization, the operation panel displays "Ready to Print" and the printer shifts to
normal
Step 5 : When using the roll media, wind back the roll media to avoid slackness at the back.
Notes
•
The printer starts the media initialization without setting the media type when
•
The [Cancel] key of the operation panel is pressed.
• No key operations are performed on the operation panel for 10 seconds.
User's Guide Océ CS9160 printer
54 AP-40790 – Rev 2.0 -23/08/2011,