Setting Media Type - Oce CS9090 User Manual

4.6.3 Setting media type

The procedure for setting media type is explained below.
Turn the printer on and load the media.
Step 1 :
Once the media has been set, the media initial menu will be displayed.
Press one of the following keys on the operation panel, and select the current media type.
Step 2 :
When alternating roll/sheet media selection: [F2]
When changing from media loading: [F3]
When changing media type: [F4]
Setup items Key
Media type F2
Lever Down/Up F3
Media Type F4
Press the [Enter] key on the operation panel.
Step 3 :
The media type has been set.
"Media Initial" is displayed on the LCD, and the printer starts the media initial operation.
Notes
•
The printer starts the media initial operation if you :
Press the [CANCEL] key on the operation panel
o
Leave the printer for 10 seconds without doing anything
o
When the media initial operation finishes, the printer moves to normal status.
Step 4 :
The setting media loading procedure has been completed.
AP-75036 - Revision 1.3 – 20/03/06
Parameters Description
Roll media Alternates the roll media type.
Sheet media • Roll media: Set when loading roll media.
• Sheet media: Set when loading sheet media.
Lever up Switches between up and down motion of the pressurizing
Lever down lever.
Use this when starting over from the media setup.
User 1 Set media type for printing.
User 2 For setup values of printing operation, eight settings of "user 1-
User 3 8" can be set.
User 4 Refer to 'Menu setup on the operation panel'
User 5
User 6
User 7
User 8
57
Chapter 4: Preparing for a job
User's Guide CS9000 series