Transfer And Transportation; Transferring The Printer - Oce CS9090 User Manual

7.6 TRANSFER AND TRANSPORTATION

This section explains transferring and transporting the printer.

7.6.1 Transferring the printer

Following are instructions for transferring the printer.
Caution
•
Keep the printer horizontally during transfer.
•
Do not tilt the printer, stand it against a wall, or turn it upside down. Doing so may cause ink to
leak inside the printer. Also, movement after transport is not covered by the warranty.
•
Have two or more people to transport the printer.
(1) Before the transfer
If you are using the stand, follow the steps below to transfer the printer.
Make sure the printer is turned off.
Step 1 :
Make sure the head is in the right edge position (capping position).
Step 2 :
Disconnect the power cable and all other cables
Step 3 :
The four adjusters are turned in the direction shown on the diagram.
Step 4 :
Transfer the printer.
Step 5 :
Notes
The caster attached to the stand has been designed for transferring the printer during short distances.
AP-75036 - Revision 1.3 – 20/03/06
1 Adjuster
2 Caster
171
Chapter 7: Maintenance
User's Guide CS9000 series