Adjust Menu; Setup Menu; Heater Menu - Oce CS6407 Quick Reference Manual

ADJUST MENU

Menu
#TEST PRINTS
>NOZZLE PRINT
#PH TO PH VAL
#YYY >+00
#PH R/L ADJ VAL
#YYY >+00
#BIDIR ADJ L XXXXXX
#YYY >+00
#EDGE SENSOR ADJ VAL
>+0.0mm

SETUP MENU

Menu
#LANGUAGE
>JAPANESE
#TIME ZONE (GMT+)
>YY/MM/DD HH:MM ZZZ
#LENGTH UNITS
>MILLIMETER
#TEMPERATURE UNITS
>CENTIGRADE
#BEEP(UNCAP CARRI)
>ON
#BEEP(TUR TIMEOUT)
>ON
#BEEP(INK ERROR)
>ON
#BOOT VERSION
*X.XX
#PRINTER FW VER
*X.XX_YY
#MAIN PCA VER
*XXXXX
#ACT PCA VER
*X.XX
#CARRIAGE PCA VER
*XXXXX
#BTC VER
*XXX
#USB ADDRESS
*XXX
#USB SPEED
*HIGH-SPEED
#FACTORY DEFAULT
>
#PRINTER FW UPGRADE
>
#DOWNLOAD
>
#JAM SENSITIVITY
>HIGH(DEFAULT)

HEATER MENU

Menu
#HEATER STANDBY TIME
>30 min
Used to print the adjustment pattern that is used for mechanical and electrical adjustments.
Used to adjust the head position (print position in the lateral direction of media) of the main scanning
direction of each print head. Enter the correction value based on the print result of [PH TO PH].
Used to adjust the right and left nozzle spotting positions of each print head. Enter the value where
the vertical lines of each color align based on the print result of the right and left adjustment pattern.
Used to adjust the shuttle position of the set media. Enter the correction value based on the print
result of [BIDIR ADJ PRINT1 to 4].
Used to adjust for correct position of image to be printed on the media. Enter the correction value
based on the print result of [EDGE SENSOR ADJ PRINT].
Select the language of messages used for LCD.
Select a time zone.
Select a length unit.
Select a temperature unit.
Set whether to emit a warning beep in the state below.
- The print head is dislocated from the cap in the daily maintenance or head height adjustment.
- The print head cannot be capped due to a media jam error during printing.
Set whether to emit a warning beep when a take-up (TUR) timeout has occurred.
Set whether to emit a warning beep when an ink error has occurred.
Displays the BOOT version.
Displays the system fi rmware version.
Displays the version of the IPB board.
Displays the version of the ACT board.
Displays the version of the HCB board.
Displays the version of BTC (FPGA).
Displays the USB address.
Displays the transfer speed of USB connection.
Sets all parameters to the initial settings at factory shipping.
Sets the printer to the online update mode.
Sets the printer to the download mode.
Select the time to maintain the standby set temperature of the heater (including the time for
transition to the standby set temperature) after printing.
Outline of functions
Outline of functions
Outline of functions
31