Head Speed Menu; Command Setup Menu - Oce CS9090 User Manual

Chapter 5: Handling the printer
Setup items Parameters
Interval <0.0 sec.> to 0.1 to 5.0 sec.
5.4.2.9

Head speed menu

Set the head speed
Setup items Parameters
HeadSpeed Normal
Fine
-

5.4.2.10 Command setup menu

Perform various settings for printer commands.
Setup items Parameters
Command setup Command
(1/2)
Step
Position
Terminator
Command setup Resolution
(2/2)
OnlineTimer
Overwrite
Halftone
Command setup -
(1/2-2/2)
AP-75036 - Revision 1.3 – 20/03/06
Description
To change interval time by operating the following keys.
• [F2] key: to increase the setup value.
• [F4] key: to decrease the setup value.
• [ENTER] key: to confirm the setup value
• [CANCEL] key: to cancel the setup value
Description
Print at normal speed
Print at half speed.
[CANCEL] key: To shift to the previous hierarchy menu.
Description
To make the settings for the conditions of printer commands sent from
the computer to the product.
To set the units for amount of movement for printing.
To set the initial writing position for printing.
To set the functions for when printing has been completed for printer
commands included in printing data.
Makes settings for image resolution while printing with image data.
Makes settings for the time between the end of receiving printing data
from a computer and recognizing the end of printing data.
Sets the printing method for areas where figures overlap on the
printing data.
When creating prints of MH-GL/GL2 (vector) data and RTLPASS
(raster) data that have not been converted into binary, set the
gradation sequence representation method.
[CANCEL] key: to shift to the previous hierarchy menu.
98 User's Guide CS9000 series