Sdm Inspection - Suzuki Grand Vitara 2011 Manual

8B-99 Air Bag System:
Removal
1) Disconnect negative cable at battery.
2) Disable air bag system referring to "Disabling Air
Bag System".
3) Remove console rear panel referring to "Console
Box Components in Section 9H".
4) Disconnect SDM connector (1) from SDM (2).
[A]
[B]
[A]: Without side-air bag and curtain-air bag
[B]: With side-air bag and curtain-air bag
5) Remove SDM (1) from vehicle.
Installation
1) Check that none of the following faulty conditions
exists.
• Bend, scratch, deformity in vehicle body where
SDM is mounted.
• Foreign matter or rust on mating surface of vehicle
body where SDM is mounted.
2) Install SDM (2) to vehicle.
CAUTION
!
Ensure that arrow on the SDM is pointing
toward the front of the vehicle.
2
1
1
2
I5JB0A820109-01
1
I5JB0A820073-01
3) Tighten SDM bolts (1) to specified torque.
Tightening torque
SDM bolt (a): 6 N·m (0.6 kgf-m, 4.5 lb-ft)
A
3
A: Vehicle forward
4) Connect SDM connector (1) to SDM (2) securely.
[A]
[B]
[A]: Without side-air bag and curtain-air bag
[B]: With side-air bag and curtain-air bag
5) Install console rear panel.
6) Enable air bag system referring to "Enabling Air Bag
System".
7) Connect negative cable at battery.

SDM Inspection

WARNING
!
During service procedures, be very careful
when handling a Sensing and Diagnostic
Module (SDM).
Be sure to read "Precautions on Service and
Diagnosis of Air Bag System" before starting
to work and observe every precaution during
work. Neglecting them may result in personal
injury or inactivation of the air bag system
when necessary.
1, (a)
2
I5JB0A820074-02
3. Ground for air bag system
2
1
1
2
I5JB0A820072-01
S6JB0A8206004