Pitney Bowes DM300c Service Manual page 211

6.4 Diagnostics
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
SBR Diagnostics (cont'd)
Last 256 Dimensions
Lists the weight (oz.), length (inches), and thickness (inches) of the last 256
mail pieces run through the machine. It also provides what width sensor (if
any) was triggered by the mail piece as it went through, and the mail piece
sequence number.
Last 256 Dimen. Captured
No Weight Length W Thick
Sequence #
004 14.060 12.625 1 0.316
(note the order
003 14.050 12.250 1 0.309
goes from bot-
002
tom to top)
001
( Weight in oz)
[Back] when done
Last 256 Dimen. Captured
No Weight Length W Thick
024
023
022
021
( Weight in oz)
[Back] when done
Reset SBR Status
The SBR Status selection is removed from the Service Menu after you run it
(e.g., after you first install a DM475 machine). The Reset SBR Status allows
you to redo the SBR Setup procedure. The SBR Status selection comes in
handy when you have replaced the WOW width sensors (WS4, WS5, WS6) or
WOW thickness or feed encoders because the program walks you through all
of the test procedures necessary for these components (see section 6.3 for the
actual procedure).
Modem Diagnostics
This item is for Engineering use only.
3.150 8.609 0 0.227
3.040 8.605 0 0.227
4.060 10.000 2 0.090
4.060 10.039 2 0.090
0.520 5.973 1 0.020
0.580 6.012 1 0.020
6 • Service Menus
Width Sensor
0= none triggered
1= Sensor 1
2= Sensor 2
3= Sensor 3 (not used in
US models)
6-15