Pitney Bowes DM300c Service Manual page 193

WOW Section of Feeder/WOW Module (use for DM475)
5.56 Feeder/
WOW
Registration
Wall Alignment
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
4. Remove one screw for brass grounding fingers on right side of bottom
chassis.
5. Loosen (do not remove):
• Two screws on bottom of metal frame for feeder/WOW control board
• Six long, washer-head screws for load cell assembly in oval adjust-
ment holes (three in front, three in back)
(this long screw is just to the right of visible screw in photo)
5 • Removal & Replacement
Brass Fingers
Screw for
Brass Fingers
Two Screws on
Bottom (loosen)
Three Long
Screws in Front
(loosen)
Three Long
Screws in Back
(loosen)
5-67