Download Print this page

Advertisement

WOW Section of Feeder/WOW Module (use for DM475)
5.54 Lower
WOW
Transport
Components
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
D. Remove right black plastic stiffener (one screw).
E. Remove e-clip and slide off middle belt roller.
F. Remove left black plastic stiffener (one screw).
G. Release tension spring on both sides.
H. Remove tension spring assembly on front (one screw) and only
loosen the tension spring assembly on the back. "Work out" shaft.
I.
Remove belts.
Tension Spring
Assembly (one
removed)
4. Reassemble in reverse order. Keep in mind the following:
Make sure the shaft is put back in correctly (short end faces the rear
and some are "d" shafts).
Put the two belts on first.
Belts should go in grooves in rollers.
Black plastic stiffeners are keyed to go in one way only
Compress springs to allow belts to go over rollers
Release tension when belts are installed, spin belts, then retighten
tensioners
Perform the feeder/WOW Registration Wall Alignment (section 5.56)
5 • Removal & Replacement
Black Stiffener
E-Clip
Cover
"D" Shaft End
WOW
Drive
Belts
Middle
Roller
5-63

Advertisement

Chapters

This manual also for:

Dm400c, Dm475, Dm450c

Comments to this Manuals

Symbols: 0
Latest comments: