Download Print this page

Pitney Bowes DM300c Service Manual: Wow Deck; Wow Unit Chassis (as A Whole Unit)

Hide thumbs

Advertisement

WOW Section of Feeder/WOW Module (use for DM475)
5.51 WOW
Unit Chassis
(as a whole
unit)
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
1. Locate and lock-down the three WOW load cell shipping screws. The
two front screws are accessed via notched holes in the feeder/WOW
deck (left photo below), while the back screw is accessed through a
hole in the interface cable compartment (right photo below).
Notched Access Holes on Deck
2. Remove the feeder/WOW module cover (section 5.39).
3. Undo two plastic clips and remove feeder harness (purple and orange
wires) from feeder/WOW control board.
4. Remove the two screws securing the back of the feeder/WOW control
board metal frame and one screw holding metal frame to bottom chassis.
5 • Removal & Replacement
Access Hole Inside Interface Cable Cavity
(interface cables disconnected)
Purple Feeder Harness
Orange Feeder Harness
Plastic Clips
Feeder/WOW Control Board
Two Screws on Back
of Metal Frame
Bottom Screw for
Chassis
5-55

Advertisement

Chapters

This manual also for:

Dm400c, Dm475, Dm450c

Comments to this Manuals

Symbols: 0
Latest comments: