Download Print this page

Advertisement

Auto-Feeder (use for DM400c/DM450c/DM475)
5.33 Feed Motor
5.34 Feed
Encoder
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
3. Remove spring (A) and loosen
belt tensioner screw (B), Fig-
ure right.
4. Walk belt (C) off motor pulley.
5. Remove two screws (D).
6. Disconnect harness (E), Fig-
ure below, right.
7. Remove motor (F).
8. Reassemble in reverse order.
1. Remove feeder unit (section
5.28).
2. Unplug connector (A).
3. Remove screw (B), and detach
encoder sensor (C).
4. Remove E-Clip and washer
(D).
5. Remove feed encoder disc (E).
6. Reassemble in reverse order.
5 • Removal & Replacement
A
B
C
Figure 5-117 Removing Feed Motor (1)
F
Figure 5-118 Removing Feed Motor (2)
A
C
D
Figure 5-119 Removing Encoder
D
E
B
E
5-39

Advertisement

This manual also for:

Dm400c, Dm475, Dm450c

Comments to this Manuals

Symbols: 0
Latest comments: