Pitney Bowes DM300c Service Manual page 161

Auto-Feeder (use for DM400c/DM450c/DM475)
5.31 Feed Roller
Assembly
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
7. Slide feed roller assembly
(right side) to front and re-
move it. See figure, right.
8. Remove screw shown in fig-
ure, right, and slide feed roller
unit (left side) to front and re-
move it.
9. Reassemble in reverse order.
IMPORTANT! When reinstall-
ing the feed roller assembly, it
is essential that you DO NOT
change the position of the
factory set separator adjust-
ment.
When removing
the gap cam
lock screw dur-
ing disassem-
bly, note where
the screw
caused an
indentation in
the plastic. See
Figure 5-106.
When reinstall-
ing, insure that the screw is
tightened in the same inden-
tation.
CAUTION! Changing this set-
ting will cause separation er-
rors.
5 • Removal & Replacement
Figure 5-104 Feed Roller Assembly (1)
Gap Cam Lock Screw
Figure 5-105 Feed Roller Assembly (2)
Indentation
Figure 5-106 Proper Setting for Gap Cam Lockscrew
Figure 5-107 Gap Cam Shown with Re-
lease Holder in Place
Feed Roller Assembly
Feed Roller Assembly
Gap Cam
5-35