Sbr Setup [Dm475] - Pitney Bowes DM300c Service Manual

6.3 SBR Setup
[DM475]
✍
TIP: Access the Ser-
vice Menu by typing
6946 and pressing
Refill Postage key.
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
SBR Setup is run when you first install a DM475 machine or when you have
replaced the WOW width sensors (WS4, WS5, WS6) or WOW thickness or
feed encoders.
1. At the main Service Menu, select SBR Setup.
NOTE 1: If SBR Setup does not display, see Making SBR Setup Dis-
play in Service Menu on previous page.
NOTE 2: If you exit at any time in the process, you will have to begin again
from this point. You will receive a warning screen before you can exit.
2. The Thickness Sensor Status screen appears. Open the feeder/WOW
cover and raise/lower the leading pair of idler rollers on the WOW up-
per transport (see figure below). This action drives the thickness encod-
er and the value on this screen should change. You are only looking for
a transition here, not a specific value. This verifies the thickness sensor
is working correctly. Press Enter to continue.
NOTE: When the leading pair of idler rollers on the WOW upper trans-
port are down, the thickness should read 0.000 inches. If any other
reading occurs, select "Re-zero sensor" and then recheck.
Thickness sensor
status
Raise/lower measurement
ski to check sensor:
0.000 in
◄ Re-zero sensor
[Enter] to continue
3. The Check Width Sensor Location screen appears. Verify that the val-
ues of sensors 1, 2, and 3 match those shown below. This sets the soft-
ware for the correct values as required by the USPS
continue.
NOTE 1: If no values are displayed, there may be no rates loaded in the
system.
NOTE 2: These are the correct settings for machines in the US. Other
countries may use different values based on their postal requirements.
See separate document for instructions.
Check Width Sensor
Location
Sensor 1 : 155 mm
Sensor 2 : 304 mm
Sensor 3 : 0 mm
[Enter] to continue
6 • Service Menus
Leading Pair
Raising/Lowering Feeder/WOW
of Idler Rollers
Leading Pair of Upper Idler Rollers
155 mm represents 6-1/8", the maximum
allowable width for a letter per USPS regu-
lations
304 mm represents 12", the maximum al-
lowable width for a flat (large envelope) per
USPS regulations
Sensor 3 is not installed on the DM475 for
the US, so this value will be "0"
. Press Enter to
®
6-5