Lower Transport Assembly - Pitney Bowes DM300c Service Manual

5 • Removal & Replacement
Printer/Base (use for all models)
5.22 Lower
Transport
Assembly
5-24
The lower transport assembly is mounted on two studs that serve as hinges.
1. Remove all printer/base covers (sections 5.2 through 5.5 and 5.7).
2. Remove the printer/base from its base pan. Section 5.6, steps 1 through 3.
3. Remove the right and left stud brackets. Each is held in place by one
screw. See Figures 5-73 and 5-74 below.
4. Maneuver the lower transport out of the machine base. The lower trans-
port is entirely passive. It contains no sensors or drive components.
5. Reassemble in reverse order.
Figure 5-73 Removing Right Pivot Stud
Bracket
Figure 5-75 Pivot Stud Bracket and

Lower Transport Assembly

Figure 5-74 Removing Left Pivot Stud
Bracket
Figure 5-76 Side and Top Views of
Lower Transport Assembly
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)