Download Print this page

Advertisement

5 • Removal & Replacement
Printer/Base (use for all models)
5.13 Printhead
Carriage
Assembly
5-14
Figure 5-38 Removing Print Head Cable at Main Logic Board
Figure 5-39 Removing Cable Keeper
NOTE: To reinstall keeper, position rear
tabs in cutout first as shown in Figure
5-40, then align the front tab with the cor-
responding cutout. Pull out the lower rear
locking tab slightly and snap the front of
the keeper into position.
9. Remove main drive belt (section
5.11.1).
10. Remove intermediate drive belt
(section 5.11.2).
11. Remove intermediate drive belt
gear to provide access to screw
securing inner carriage rail. See
figure, right.
12. Remove rail mounting screw and
slide shaft toward front of machine
(Figure 5-42 and 5-43).
13. As the shaft is released from both ends,
push it toward the center of the machine
to free it from the print carriage. (The
shaft will snap out of position.)
Figure 5-40 Installing Cable Keeper
Figure 5-41 Removing Intermediate Gear
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
Rail
Mounting
Screw
below Gear
Stud

Advertisement

This manual also for:

Dm400c, Dm475, Dm450c

Comments to this Manuals

Symbols: 0
Latest comments: