Pitney Bowes DM300c Service Manual page 183

WOW Section of Feeder/WOW Module (use for DM475)
5.51 WOW
Unit Chassis
(as a whole
unit)
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
8. Lift up and out whole WOW unit assembly.
9. Reassemble using this order, keeping in mind the following:
A. Place unit in bottom chassis (tub). Be careful the rear does not get
caught on the feeder unit.
B. Fasten the six long washer-head screws, but back off a 1/4 turn from
fully tightened. This allows you to adjust the WOW unit.
C. If the feeder/WOW board is attached, insure that the bracket screws
are loose.
D. Perform the feeder/WOW Registration Wall Alignment (section 5.56)
E. Once the adjustment is done, insure that all screws (three on board
bracket, 6 - load cell to tub, 1 - grounding fingers) are tightened.
F. Fasten two feeder harness cables (orange and purple) to feeder/
WOW control board.
G. Recalibrate the WOW load cell. Access the Service Menu and navi-
gate to WOW Options (see section 6.5). Perform the WOW Calibra-
tion and Static Weight procedures.
5 • Removal & Replacement
WOW Unit
Removed from
System
5-57