HP NetServer AA 4000 Manual page 42

Hp netserver aa 6200 solution release 3.0 messages
Hide thumbs Also See for NetServer AA 4000:
Table of Contents

Advertisement

Chapter 1
Table 1-5HP NetServer AA Message Summary – Prefixed Messages (Continued)
Message
IOPn.MtcScsiP status: DEVICEn has a SCSI logical unit number (LUN) different than
configured on the other IOP, and it will be marked offline.
IOPn.MtcScsiP status: DEVICEn has a target ID different than configured on the other IOP,
and it will be marked offline.
IOPn.MtcScsiP status: DEVICEn location contains an unsupported device.
IOPn.MtcScsiP status: DEVICEn location does not contain the expected device type.
IOPn.MtcScsiP status: DEVICEn powered up successfully.
IOPn.MtcScsiP status: DEVICEn was not found, and it will be marked offline.
IOPn.MtcScsiP status: Disk could not be enabled.
IOPn.MtcScsiP status: Disk is a mirror copy target. Status is offline pending copy start.
IOPn.MtcScsiP status: Disk is already disabled.
IOPn.MtcScsiP status: Disk is already online.
IOPn.MtcScsiP status: Disk must be offline.
IOPn.MtcScsiP status: DISKn cannot be accessed for initialization, and it will be marked
offline.
IOPn.MtcScsiP status: DISKn cannot be physically accessed. See prior events for reason.
IOPn.MtcScsiP status: DISKn contains an invalid partition table. The disk must be
repartitioned.
IOPn.MtcScsiP status: DISKn contains too few partitions. Use Disk Administrator in
Offline HP NetServer AA I/O Processor Mode to partition the disk, making sure to add an
HP NetServer AA partition.
IOPn.MtcScsiP status: DISKn copy target on IOPx has been newly installed, but copy
source on IOPy has not. Install CE and IOP software on copy source (IOPy).
IOPn.MtcScsiP status: DISKn could not be enabled. Check prior events for reason.
IOPn.MtcScsiP status: DISKn did not come ready, and it will be marked offline.
IOPn.MtcScsiP status: DISKn did not power up properly, and it will be marked offline.
IOPn.MtcScsiP status: DISKn does not have a bootable partition. Use Disk Administrator in
Offline HP NetServer AA I/O Processor Mode to mark the desired boot partition as active.
The disk will be kept offline until it contains a partition marked as bootable.
32
Introduction
Page
page 312
page 312
page 312
page 313
page 313
page 313
page 313
page 314
page 314
page 314
page 314
page 315
page 315
page 315
page 316
page 316
page 316
page 317
page 317
page 318

Advertisement

Table of Contents
loading

This manual is also suitable for:

Netserver aa 6200

Table of Contents