HP NetServer AA 4000 Manual page 321

Chapter 14
IOPn.MtcScsiP status: Device DISKn will be faulted because it is taking too long to complete SCSI requests. The IOP
must be rebooted before the disk can be enabled.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Error
Description A disk has not completed pending SCSI requests in an appropriate time period. This typically
occurs as a disk begins to fail. However, it is also possible that incorrect SCSI termination
settings or bad SCSI cabling are to blame.
Action • Reboot the IOP and check the SCSI termination settings, the SCSI cable integrity, and the
• If these items all appear to be correct, consider replacing the disk.
IOPn.MtcScsiP status: DEVICEn has a SCSI adapter number different than configured on the other IOP, and it will be
marked offline.
Variables n – the device number; for example, DISKn, CDROMn, TAPEn
Severity Error
Description A configured SCSI adapter for the device on the local IOP does not match the configured
adapter number for the device on the remote IOP.
Action Use the HP NetServer AA Configuration Utility to fix the configuration files on each IOP so
that this device has the same SCSI adapter number on each IOP.
IOPn.MtcScsiP status: DEVICEn has a SCSI bus number different than configured on the other IOP, and it will be
marked offline.
Variables n – the device number; for example, DISKn, CDROMn, TAPEn
Severity Error
Description A configured SCSI bus number for the device on the local IOP does not match the configured
SCSI bus number for the device on the remote IOP.
Action Use the HP NetServer AA Configuration Utility to fix the configuration files on each IOP so
that this device has the same SCSI bus number on each IOP.
SCSI cable connections.
MtcScsiP and MtcScsiR Messages
311