HP NetServer AA 4000 Manual page 335

Chapter 14
IOPn.MtcScsiP status: DISKn has an invalid partition signature. Use Disk Administrator in Offline HP NetServer AA
I/O Processor Mode to partition the disk, making sure to add an HP NetServer AA partition.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Error
Description The disk does not have a valid partition table. It must be partitioned and formatted.
Action Repartition the disk. See
details about repartitioning a mirrored disk.
IOPn.MtcScsiP status: DISKn has an IOP ID other than the current IOP ID. This indicates DISKn has come from a
different IOP. The HP NetServer AA partition can be reset to cure this condition, but caution is advised. If unsure
how to proceed, contact your service provider for assistance.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Error
Description A disk that belongs to another IOP has been moved to the local IOP. The disk must have its
HP NetServer AA partition reset if it is to be used in the local HP NetServer AA system.
However, if the disk's HP NetServer AA partition is reset, it is very likely that it will become
a mirror copy target, causing any stored data on the disk to be overwritten. Additionally, there
are scenarios in which the disk could become a mirror copy source, causing any stored data on
the other existing mirror set member to be overwritten. See the action section for details.
Action This condition should only occur if a replacement disk has been taken from elsewhere and used
to replace a faulted disk.
• In this case, assuming the CEs are up and running, you can reset the disk's HP NetServer
• However, if this scenario is not desirable, or the CEs are not up and running, contact your
Chapter 9
AA partition, and it will become a mirror copy target.
service provider before continuing.
MtcScsiP and MtcScsiR Messages
in HP NetServer AA Solution Administrator's Guide for
325