HP NetServer AA 4000 Manual page 258

Chapter 13
IOPn.MtcMon status: Client registration failed on the local IOP. Client ID = x.
Variables x – the ID of the client that failed the registration process with the Monitor:
Severity Error
Description When a Monitor client is loaded, it registers itself with the Monitor. If the registration is not
valid, this message is generated. The registration fails if any of the following are detected:
• The client ID is not in the Monitor's ClientList registry parameter.
• The client is already registered with the Monitor.
• The client specifies an invalid parameter in its registration information.
• The client ID provided during the registration attempt is not valid.
Hardware/Software This message is due to either an Endurance server software configuration error or an
Endurance server internal error.
Action • The client ID specifies which Endurance software component could not be registered. The
• Reinstall Endurance software on the IOP.
• If the condition persists, issue an IOP Disable Operation command and run the Endurance
248
Client ID Client Description
2 Floppy
4 Serial Provider
8 Keyboard/Mouse Provider
10 Endurance
Event Provider
11
Endurance
Device Synchronization
Layer
12 Endurance
Monitor
C
Endurance
Ethernet Provider
E Endurance
SCSI Provider
Monitor's ClientList Registry parameter should be examined to determine if the given
client should be registered with the Monitor. If the client ID does not appear in this list, it
should be added to the list or it should not be loaded.
server with a single IOP. Contact your service provider for assistance.
MtcMon Messages
Client Image Name
MtcFloP.Sys
MtcSerP.Sys
MtcKmP.Sys
MtcEvtp.Sys
MtcDsl.Sys
MtcMon.Sys
MtcEthp.Sys
MtcScsip.Sys