HP NetServer AA 4000 Manual page 128

Chapter 7
IOPn.MtcEthP status: Device x (y) network connectivity lost.
Variables x – the logical device identifier for this adapter (for example, Ethernet0)
y – the Windows NT device name (for example, E100B2)
Severity Error
Description The Ethernet Provider network monitoring has determined that the device lost network
connectivity. If it is the active (primary) Ethernet adapter for the HP NetServer AA server, the
network traffic fails over to the standby Ethernet adapter.
The former primary device remains enabled so it can detect when the cable is repaired.
Action • Check the Ethernet cable. Use the HP NetServer AA Manager to examine the port
• Check the LEDs on the NIC.
• Use the
• If the cables are properly connected, but the device remains in the offline state, try
• If the condition recurs:
IOPn.MtcEthP status: Device x (y) network connectivity restored.
Variables x – the logical device identifier for this adapter (for example, Ethernet0)
y – the Windows NT device name (for example, E100B2)
Severity Informational
Description This message is logged when network connectivity is restored following a failure.
Action No action is required.
118
counters for the device to determine if packets are being received.
MTCEINFO Tool
Administrator's Guide, to monitor the error counters maintained by the adapter.
rebooting the IOP. (Refer to
Guide for information about how to reboot an IOP. In this case, you should power cycle
the IOP when you reboot it.)
- Replace the Ethernet cable.
- Run the manufacturer's diagnostics.
- Replace the NIC.
,
described Chapter 7 in HP NetServer AA Solution
Chapter 9 in HP NetServer AA Solution Administrator's
MtcEthP and MtcEtx Messages