HP NetServer AA 4000 Manual page 158

Chapter 9
IOPn.MtcFLOP status: The Floppy Provider attempted to attach a floppy device to the floppy driver's device object,
but failed. As a result, that floppy device will be inaccessible.
Severity Error
Description One of the following problems has occurred:
• The floppy device was not properly defined using the HP NetServer AA Configuration
• The floppy driver could not find any floppy devices.
• The floppy driver is not running.
Action • Using the HP NetServer AA Configuration Utility, check the configuration information
• Make any necessary corrections.
• Remember that when you make a change using the HP NetServer AA Configuration
• On the IOP where the floppy devices physically reside, use Start
• Check the Event Viewer for a Windows NT message stating that the floppy driver failed to
IOPn.MtcFLOP status: The Floppy Provider attempted to create a floppy device, but failed. As a result, that floppy
device will be inaccessible.
Severity Error
Description The floppy device failed initialization. This error usually occurs because the device is not
configured properly.
Action • Using the HP NetServer AA Configuration Utility, check the configuration information
• Make any necessary corrections. Remember that when you make a change using the HP
• Because any changes will not take effect until the IOP reboots, schedule an appropriate
148
Utility.
that you supplied for each floppy device.
Utility, you must make the same change on both IOPs. (The IOPs must contain identical
configuration files.) Because any changes will not take effect until the IOP reboots,
schedule an appropriate time to reboot the IOPs.
Control Panel Devices and make sure that the "Floppy" is listed and shown as
running.
initialize. If this message was logged, Windows NT did not initialize the floppy driver.
Refer to Windows NT documentation for information.
that you supplied for each floppy device.
NetServer AA Configuration Utility, you must make the same change on both IOPs. (The
IOPs must contain identical configuration files.)
time to reboot the IOPs.
MtcFLOP and MtcFLOR Messages
Setting